Line 6 Helix LT Guitar Processor

Product Information

In some cases, Command Center > HX Looper commands would not function while in Preset Spillover mode— FIXED

We obtain the categories of personal information listed above from the following categories of sources: Interval 1—Sets the pitch of some slices, the likelihood of which is determined by the Pitch parameter (from an octave down to an octave up) Low Cut— Applies a low cut (high pass) filter to the speakers, letting you remove the effected signal below a certain frequency Mix— Controls the wet/dry mix of the reverb. When set to 0%, no reverb is heard; when set to 100%, no dry signal is heardExternal connection facilities are also halved here, with just two send and return loops to incorporate external effects in the signal chain, although that should be sufficient for most players to add a couple of favourite stompboxes, which can then be used as part of a preset. In use

HX Edit can't magically pull new model names and graphics from your Helix/HX hardware; you must update HX Edit as well (which you would've done had you followed "How do I update to 3.70?" above). Mix—Controls the wet/dry mix of the reverb. When set to 0%, no reverb is heard; when set to 100%, no dry signal is heard. You have the right to request that we delete any of your personal information that we collected from you and retained, subject to certain exceptions. Once we receive and confirm your verifiable consumer request, we will delete (and direct our service providers to delete) your personal information from our records, unless an exception applies. Diffusion—Sets the amount of smearing between discrete echoes, sometimes resulting in a softer effected signal. Distance—Sets the distance of the mic from the speaker cone. Choose from 1.00" to 12.00" in 1/4" increments

Knobs 1-6

David (my sales rep) was amazingly helpful throughout the process. I called a couple times weighing my options and he was awesome.

We've all struggled with fiddly interfaces and overwhelming lists of menus, switches and parameters - this can make it difficult to change settings in real-time and adapt to your musical surroundings. Line 6 went above and beyond to make sure that wasn't the case with the Helix.The Essex A30 model could stop passing audio after roughly 2 minutes when its drive parameter is set to 10.0— FIXED